An inductor constructed by layering the coil between layers of core material, the coil typically consists of a bare metal material( no insulation), this technology is sometimes...
Epoxy coated Inductor
Inductors that have been coated with epoxy as opposed to haveing a molded case, shrink wrapped tubing or left with an open construction body, epoxy coated inductos typically...
"But that's my point: is ISN'T 12V during the dead time, it is either 0V or 24V, which makes no sense when both MOSFETs are off?"
But that's my point: is ISN'T 12V during the dead time, it is either 0V or 24V, which makes no sense when both MOSFETs are off?
The drain is always pulled up to 12v through the transformer center tap winding to 12v. It is pulled to ground when the gate is high. During the deadwally7856 03-08-2014, 09:05 PM
I am curious about this, because having looked at various designs for push-pull converters, some seem to have an output inductor, some don't. What gives?daviddeakin 03-08-2014, 04:25 PM
I built the boards myself. The layout was done using EAGLE and the PCBs were fabricated using Fusion PCB. I bought an evaluation
dear microsIM, i pm you, i also need the ebook. appreciate if you can send me the link to download.
thanks in advance