PDA

View Full Version : Quad Die Lateral MOSFET Amplifier



Aussieamps
03-27-2013, 11:24 PM
Hi Everyone

This is one of my latest amplifier modules.
It uses a pair Exicon's Dual Die Lateral MOSFET's, the power output from this small module is quite impressive at around 340 watts RMS into 4 ohms.
This is using a +-70 volt supply rail, lower supply rails can be used on this module for lower power outputs. Typically +-35volt rails would work just fine with this module.
The PCB measures 66mm x 50mm
Power Bandwidth of this module is approximately 250khz -3db
THD+N 0.01%

Cheers

Anthony
www.aussieamplifiers.com

3737

khalsa
03-28-2013, 04:04 AM
Hello sir Holton nice amp and compact size

Aussieamps
03-28-2013, 04:27 AM
Hello sir Holton nice amp and compact size


Thanks khalsa

pritam kundu
08-26-2015, 06:09 AM
Compact design.... Looking good..nice work sir,,,.

DjLeco
09-09-2015, 12:28 AM
Some measurements?

Sinewave at 100Hz 2 volts under clipping and rectangular at 10kHz, the same, on 8 ohms dummy load?

Thank you!

Nice work!